tin snips การใช้

• Use scissors or tin snips to cut a patch larger than the hole.
• It is so tough that it has to be cut with tin snips.
• Trim away any excess liner with tin snips or heavy-duty shears.
• The mesh is tough; it has to be cut with a tin snips.
• "Sometimes we have to use tin snips to cut them, they're so fibrous and tough,"
• "You could see it burning right over there, " he says, pointing with his tin snips.
• Unlike standard tin snips, aviation shears have compound lever-action handles that provide extra power for metal cutting.
• You will need tin snips to cut the ducts to length and to cut holes for a connecting branch.
• Try prying up the aluminum and cutting it with tin snips to get a piece out, one at a time.
• Cutting copper must be done with special shears, not tin snips, and sanding copper can create breathing problems and severe itching.
• He uses tin snips to cut the metal, then bends it into cones to use on Apache clothing and burden baskets.
• Use a pair of tin snips to cut the metal to rough shape, then use small files to define the exact profile.
• You can use ordinary tin snips for cutting sheet metal, but straight-cutting aviation shears are better because their compound-action handles increase cutting power.
• For larger leaks, you may have to get some tin snips and cut a strip of metal flashing to fit over the damaged area.
• They are often used to cut or shape metal when the stock is thick and where other tools, like a hacksaw or tin snips, would be unsuitable.
• Later on you can add other tools : a back saw and miter box, a wire brush, tin snips, a staple gun, channel pliers and a soldering iron.
• In 1927, John W . Hammes, a Racine, Wis ., architect, began to tinker with tin snips and a soldering iron after watching his wife carry out garbage.
• On the evening of November 6, 1997, the'T's were nearly stolen from the north, south and west sides of Tech Tower by five students wielding hacksaws, tin snips, and rappelling equipment.
• You can get by with almost any kind of tin snip, but aviation shears will make the cutting job easier, especially if you have to work in cramped quarters ( between joists ).
• You'll only need a few simple tools for this job : a wall board saw, a keyhole saw, a drill, a screwdriver, a utility knife, a hammer and a pair of tin snips.