fuze การใช้

• These ships used the Fuze Keeping Clock HA Fire Control Computer.
• The fuze and warhead were adapted from the earlier Mauler program.
• Later reissued Mk II variants featured the modern M204 series fuze.
• This would dial in the ordered fuze time into that projectile.
• The top has a fuze well directly threaded in its center.
• It weighed 75-92 pounds and used a proximity fuze.
• The tilt fuze is typically a home-made mercury switch.
• Its fuze delays detonation 4 seconds after the spoon is released.
• Fuze launched over 40 new products and line extensions since its inception.
• On impact with the target, a delayed action fuze is triggered.
• It has a fuze failure rate of 3 8 %.
• It used a radar proximity fuze and semi-active radar homing.
• It is detonated just above ground by a fuze extender.
• Tools are not required to install or set the fuze.
• The fuze screws into the body, and is replaceable after use.
• The M26A2 is an M26A1 modified to accept an M217 impact fuze.
• The top had a threaded fuze well in the center.
• The M603 fuze is inherently safe to handle and much more reliable.
• The mine uses either a UPM-1 or UPM-2A fuze
• The fuze contains an integral anti-handling device to hinder deminers.