isolator การใช้

• The analyser then enables the light to be transmitted through the isolator.
• Typically collimators are used on either side of the isolator.
• Figure 3 shows the propagation of light through a polarization independent isolator.
• Thus, the actual workstation isolator is always maintained under substantial positive pressure.
• A network isolator can be constructed to provide one or both required MOPPs.
• Sapronov was expelled from the party at the isolator.
• It is a conveyor and not an isolator.
• Opto-isolator sensors are completely encased to prevent ingress from the outside environment.
• A common type of opto-isolator consists of an lamp-photoresistor pairs.
• While isolator usage continued to expand, RABS also became popular in the 1990s.
• The physical layout of an opto-isolator depends primarily on the desired isolation voltage.
• This proposed analog isolator is linear over a wide range of input voltage and frequency.
• This continuous hallway acts as an acoustical isolator and is surfaced with sound absorbing material.
• A passive isolator can be seen as a mechanical low-pass filter for vibrations.
• The light from the SLD passes through an optical isolator and subsequently a polarization controller.
• Is this sufficient RS to say that the original opto-isolator trademark has expired?
• An opto-isolator connects input and output sides with a beam of light ground wires.
• To achieve non-reciprocity, an isolator must necessarily incorporate a non-reciprocal material.
• An isolator will be placed under every load-bearing column and wall below the basement level.
• A novel idea of a particular optical analog signal isolator was submitted on 3, June 2011.