kilohm การใช้

• A 10 kilohm pull-up resistor is attached to pin 4 ( PRESENCE # ).
• When the HDA dongle is plugged in, it pulls pin 4 to ground with a 1 kilohm resistor.
• For ease of use, the doubled vowel was removed from kilohm and megohm ( instead of using kiloohm and megaohm ).
• Physical inductors are typically limited to tens of henries, and have parasitic series resistances from hundreds of microhms through the low kilohm range.
• The value of R 1 would depend on the JFET or triode chosen, and perhaps be a 200 kilohm preset, adjusted to give lowest distortion in the output signal.
• Commonly used multiples and submultiples in electrical and electronic usage are the microohm, milliohm, kilohm, megohm, and gigaohm; the term " gigohm ", though not official, is in common use for the latter.
• Since resistors are specified and manufactured over a very large range of values, the derived units of milliohm ( 1 m? = 10  " 3 ? ), kilohm ( 1 k? = 10 3 ? ), and megohm ( 1 M? = 10 6 ? ) are also in common usage.