backsaw การใช้

• Use the backsaw to remove the corners on the bottom piece.
• The backsaw is used to make precise cuts, usually with a miter box or bench hook.
• The backsaw cannot cut completely through the damaged siding because the top will be covered by an overlapping board.
• Drive wedges under the board to raise it away from the wall, then use a backsaw to make cuts on either side of the damage.
• Take a matching piece of wood and with a backsaw or a dozuki, cut a tiny cross-grain square sliver and carefully sand it to a point.
• The ends of the piece will be irregular, but you can square them off with a backsaw . ( Cutting through plaster will dull saw teeth so use an old saw .)
• I might start the cut with a backsaw held vertically, to create a starting kerf exactly where the cut is to be, then saw the rest of the way through the baseboard with a saber saw and a flush-cutting blade, which projects in fromt of the saber saw.
• You will only need a few common shop tools to make the birdhouse : a rip saw, a backsaw, a block plane, a ruler, pencil, try square, a drill with {-inch and 1 {-inch bits, a hammer, a nail set, galvanized nails, sandpaper and a paintbrush.